(1) Add button:

Click the button to add a button in the upper left of the figure, and a button will be added, which will be displayed in the middle of the screen, so you can add a few buttons if there are several buttons on your handle. After adding the button, click the first button with the mouse. At this time, we first press the 1 button on the handle to see which point below responds. After seeing the reaction point, we hold down the 1 button on the handle, and then Click on the responding point (note that the upper and lower dots are separated, don’t click two or more). After clicking it, it will feel a little yellowish. Then release the 1 button on the handle. At this time, we just The dot you click will turn into a yellow dot:

At this time, we have completed the 1 key, and then the 2 key, we click the second button above, and then press the handle 2 key to see which dot below responds (usually next to the 1 key dot), After seeing which one is responding, we press and hold the 2 button, the method is the same as the 1 button, set all the buttons in turn (except for the arrow keys and joystick). If you always return to the previous button by pressing the button on the handle after clicking the next button, please click the red cross in the upper right corner of the button to delete the previously set button and add the button again.

(2) Add arrow keys:

It should be noted here that the setting of the arrow keys is not the same as the setting of the keys. The setting method: click the arrow button in the upper left corner of the interface (below the addition of the common button) (we can click one, not so many, because one You can set all the arrow keys), then you pick up the handle and press all the arrow keys once, up, down, left, and right. The corresponding small dots will respond. If you see the response, click the mouse in turn, (note that you don’t need to hold down The arrow keys on the handle, just click with your mouse. This is different from the button). Just click the two lines according to the following picture:

At this time, we press the arrow keys on the handle to see if the arrow buttons above will move with your arrow keys, which proves that the arrow keys are also set.

(3) Key pairing:

It’s not finished yet, let’s go back, go back to the previous interface and click on the icon recognized by your handle, then there are a bunch of button names, A B C D UP and so on.

We just click a letter and then press a handle button until all the buttons on the handle are clicked. The same is true for the arrow keys. If successful, the letter will turn into a red box.

OK, here the part of the software is set up. After exiting this program (the setting in the emulator will not be successful after exiting), then open a game console emulator.